Reapter

contact us
Location: Home >Q & A

What is the best material for the plate heat exchanger rubber gasket? How do I install it?

Return list Reffer:Reapter
What is the best material for the plate heat exchanger rubber gasket? How do I install it?
Click number:- Release time:2020-06-24

Many people often ask what adhesive to use for the plate heat exchanger gasket and how it should be installed after they have purchased the equipment. Actually, ah, there are two layers to this, the first is how the rubber mat is hung and the second is how to properly mount the mat to the Plate Sheet.

 

There are three ways to install the plate heat exchanger glue pad, which have been described before in the article. This is a stick-on pad, because only the stick-on type requires glue, the other two types, such as snap-on and snap-on, do not. Glue is required. So, what is the typical glue needed for paste type?

 gasket for plate heat exchanger (1)

Adhesive pads are commonly used on heat exchangers with 3M glue, imported from the U.S., for heat exchangers, which is fast-drying 3M glue can be heat cured, weather resistant, aging.3M glue is available in a wide variety of types, be sure to buy heat exchanger-specific when communicating with the vendor! Otherwise, it doesn't work very well.

 

But 3M glue is perfectly suitable for plate heat exchanger pad? Not really, once when we were shipping to a customer in the U.S., the customer specified 3M glue, but after more than a month of The shipping period, after the goods arrived in Hong Kong, disassembled and found that the adhesive gasket has not stuck, which has many factors. Qingdao Ruipute heat exchanger equipment manufacturing Co., Ltd. secret heat exchanger special adhesive pad, good effect, strong paste, does not hurt the plate. Long service life, good sealing performance, the customer has never had any problem in the process of use.

 

Paste rubber pad in the installation of the time to pay attention to the rubber pad do not bring any dust, the plate sheet groove should also be wiped clean, and then the paste applied to the groove, and then pressed flat into the rubber pad, bonding is from one section to the other end of the board, flattened and placed for a period of time can be.

 

I believe that after reading these times you will understand the plate heat exchanger pad with what glue is good, of course, along with how to install also told you, do-it-yourself replacement pad, there will be no problem, as long as you follow what we said to do.

Relevant article

Latest information